We expect the pretty Fournier RF-4D motor glider to be very popular. With a
wingspan of 2 metres, it is available with either blue or red trim. Weighing in
at just 1.8 Kg, a 250-300W brushless motor (not supplied) will provide ample
power for getting aloft, after which you can switch the motor off and enjoy
some serene thermal soaring. Or power on for some gentle aerobatics. Remember
the Rothmans dual display team?
Requires four channel R/C and four small servos.
Features:
• Precision assembled using laser cut parts
• Lightweight balsa and ply used throughout
• Airframe parts individually sealed in clear plastic bags
• Pre-painted plastic cowl with dummy exhaust pipes
• Pre-assembled ply motor mount
• Pre-assembled outriggers
• Hardware pack including main wheel, metal clevises, laser cut wing spar and
control horns
• Spring operated battery hatch. Change batteries quickly without taking off the
wings.
• Painted top body pilot figure with cloth jacket
• Pre-fitted canopy
• Ready covered in pre-printed heat-shrink Polycote ECS. Avoids separate trim
pieces that can lift and look scruffy after just a few flights. Slack areas can
be re-tightened using a heat-gun on a low setting
• Pre-fitted mini servo tray.
• Dual snake elevator push-rod and single snake rudder push-rod with pre-fitted
metal clevises
• Pre-fitted tail-wheel assembly
• Aileron servo Y harness
• Tailplane central gluing area is pre-cut and film removed to prevent tailplane
failures
• Assembled using clear adhesive which runs into the joints making proper bonds
rather than just sitting as a fillet on top
• Full Colour Assembly Manual
Please note: Kit contents may vary slightly from those listed here. To retain
the integrity of the original packaging we are unable to check each individual
kit.
